Site Investigation – Page 4

7 October, 20157 October, 2015

A Week in the Life…..

No-one can say that our workload isn’t varied. Last week one of our drilling crews completed the following schedule:
Monday – Geotechnical investigation including U100 sampling and SPT testing with our Terrier drill rig;
Tuesday – Water well installation using rotary rock roller with our Commachio 205;
Wednesday – Environmental investigation at a filling station using hollow stem augering, again with our Comacchio 205, while a new canopy was being installed;
Thursday and Friday – Deep water well installation using down the hole hammer to penetrate into a limestone aquifer.
We love a bit of variety in life and this week has proved it so. Time for a rest…….next week looks busy………

12 May, 2015

Greek Myth?

Actually, there is nothing mythical about Subadra being commissioned to install shallow monitoring wells at the Daedalus Airfield Development! We constructed several shallow wells over the course of two days using our Hollow Stem Auger drilling system.

Lee-on-Solent is known for its sand and a dense gravels which are more or less guaranteed to make drilling difficult. So to avoid this we used our powerful Comacchio drilling rig which ensure we reached the target depth at all the drilling locations with minimal disruption to the site. We then installed 50mm diameter wells to allow future groundwater sampling. All our materials were sourced locally to enable us to take the minimum of equipment and vehicles thus reducing our carbon footprint for the works.

We even had time to the collect soil samples for the Principal Contractor and get them
analysed for WAC by our in house lab facility. As a result of our prompt and efficient service the client retained us to carry out a more detailed geotechnical investigation at the site. No myth there then!

13 April, 2015

Everybody Breathe In

Terrier - Restricted Access — Terrier – Restricted Access

The combination of restricted head room and a ‘confined space’ presents major obstacles to any site investigation. However, our Terrier rig was able to gain access and complete a geo-environmental investigation in such a space. Its quite amazing where this little rig can get.
Access was through a standard doorway working with an overhead ceiling clearance of
less than 30mm with the machine set up. Precision operation was required to ensure we completed five boreholes, each to 6 metres in depth, with SPTs every metre, all in a safe and efficient manner.
The nature of the confined space meant that exhaust gases from the Terrier’s engine had to be vented to an outside area. We used an extendable sectional exhaust pipe to ensure a safe working environment. But just in case we also carried out carbon monoxide monitoring to ensure our crew’s safety.
Even better, our work was completed without the need to close the car repair workshop we were working in. allowing our client to continue panel bashing, filling and spraying to his hearts content.

6 March, 20156 March, 2015

Big Old Tanks

Have you ever wondered what is below your feet when you’re filling up at a petrol station? Big old tanks, that’s what! We’ve investigated the ground at more filling stations in the UK than anyone else and so, not surprisingly, we have a have a pretty detailed understanding of how they are put together. This sort of experience is invaluable when
it comes to assessing potential environmental risk – we know how and where problems
can occur…

Obviously owning our own specialist drilling systems, UKAS and MCerts accedited
laboratory and remediation equipment also has benefits, both in terms of cost and speed of turnaround.

For pragmatic advice and cost effective assessment strategies for the assessment
of filling station sites please contact James Skinner on 07770 611554.

6 March, 20156 March, 2015

When You Need to Know Fast

Our Geoprobe Drilling Systems offer something a little special when it comes to rapidly investigating a site. And when coupled with the fast turnaround from our UKAS and MCerts laboratory, our clients benefit from the best of all worlds.

We were asked to investigate a large industrial site that had a history of fuel contamination issues. The question was: how far had the contamination spread and was it migrating under the neighbouring properties. Our solution was to carry out a groundwater probing survey, comprising driving a re-useable probe into the ground to the underlying groundwater and then taking a sample of the groundwater for laboratory analysis.

We completed 54 probes in two days, accurately delineating the hydrocarbon plume. Forensic analysis of the samples by our laboratory then confirmed that there were three separate sources of the hydrocarbons, two of which were ongoing leaks, and not just the one known historic source.

We now know what the problems are, how far the contamination has spread and how to clean it up. Isn’t that better than endless phases of investigation last months and costing £££s.

Project value: £10-£15k

5 November, 20145 November, 2014

White Cliffs of Dover

We were commissioned to carry out a geotechnical investigation, including rock coring, at a site located just a stone’s throw from the busy harbour of Dover.

Our Commachio 205 and drilling crew were able to produce high quality cores and gain SPT/CPT data from 4 boreholes, each drilled to a depth of 20m below ground level. All completed on time and on budget.

Voids were encountered at various depths fueling rumours of secret smuggling tunnels similar to those we found in Margate last year. Unfortunately the only treasure recovered were metres and metres of chalk. Better luck next time lads!

11 July, 2014

Tight Access for Investigation

We have recently completed an incident response investigation of a domestic heating oil installation located at the centre of a residential accommodation block complex in southern England. The site overlies chalk and is located just 100m from a public drinking water supply borehole.

Following complaints of possible oil contamination issues from the residents we took samples of the underlying soils and audited the fuel installation. With only footpaths leading to the tank installation we used our Terrier drilling system – which can fit through a standard doorway – to install boreholes either side of the oil tank and take soil samples for rapid analysis in our UKAS laboratory. Fortunately no significant soil contamination had occurred and our recommended improvements to the installation are now underway. The entire project, from initial enquiry instruction to report issue, was completed in under 4 days.

Project value ~£2k. Client value £££

21 May, 201421 May, 2014

Pile Probing Challenge

We do like a challenge, so when a client asked if we could probe 65 pile locations in a single day we said yes. Just to make it more of a challenge our client also wanted soil samples taken from each location and analysed for a range of potential contaminants.

The site was an office car park crammed with cars during the week, so the probing had to take place at the weekend. With noise restrictions preventing Sunday working and project deadlines meaning the work had to be completed in a single day, we knew we would have our work cut out. Each location required us to core the surface pavement, take a soil sample from the upper metre of soil profile and probe to 3.6m depth – a total of 234m of probing. But happily, using our Geoprobe Direct Push drill rig we were able to get everything completed in time to see the kick-off of the FA Cup.

The soil samples were dropped off at our own laboratory later the same day for ‘fast track’ analysis and the results provided to the client 3 days later.

3 April, 2014

Could this be summer?

Sometimes it really just isn’t that bad to be on site! Could this be the start of a long, hot summer? We hope so.

21 November, 2013

Property Portfolio Due Diligence

Subadra has just completed environmental investigations at a portfolio of 25 retail petrol filling station sites on behalf of a major oil company. The project was brought to completion on time and on budget, using a combination of our own drilling equipment, our in-house UKAS accredited laboratory and reported by our highly experienced consultants.

Contract Value: £100-200k